Showing posts with label bearings. Show all posts
Showing posts with label bearings. Show all posts

Monday 6 October 2008

Brassed off

My first attempt at an extruder had stainless steel bearings and a stainless steel drive shaft, more by accident than anything else. I wondered at the time how the bearings would last compared to the recommended brass ones. Obviously stainless steel is harder than brass, but brass should have less friction, so less wear.

The first drive shaft got retired because the bearing lands were off centre. At the end of its life the bearings and lands were still in good condition.



I ran it from 10/07 to 01/08 but up to that point all I had made was lots of HDPE test shapes.

I replaced it with a plain steel shaft that I bought from BitFromBytes. That had the big advantage of being solder-able.

It worked well for a long time but eventually the bottom land on the shaft wore down so much that the pump halves closed together when using undersized filament (2.7mm).



The bottom land has worn down from 3mm to 2mm. The bearings show a little wear but still have some life left in them. This is after running 5lbs of ABS through the extruder.



In the last few weeks I replaced the shaft with a new zinc steel one and switched to brass bearings in an ABS extruder with HDPE filament guide. That worked well until I noticed the pump halves closed together again. When I opened it up I found that the brass bearings had rotated in the ABS, but they had also worn down a lot, considering the short time I had used them.



The drive shaft lands are still fine though.



So it would appear that the best combination is stainless steel bearings and a stainless steel shaft, but I would have to find another way of attaching the nut.

Most metal bearings I have recovered from old equipment are bronze. I don't know how that compares to brass but it seems to be the thing to use.

Maybe it is time to look at ball bearings and an offset shaft like Ian Adkins' design.

Sunday 22 July 2007

Bearing up

The bearings for the extruder pump are supposed to be made from brass and I had a bit of brass rod earmarked for the job. It is only 9mm diameter but the bearings are supposed to be 10mm. I had planned to make the holes in the pump housing smaller to compensate but I forgot. While wondering what to do I just happened to find a 10mm steel pin lying around at a rubbish tip.



The fact that there is no rust on it suggests that it is some form of stainless steel. It is certainly quite hard. I tried to cut it on the lathe with a parting off tool and all it it did was take the tip off the tool.



I next tried cutting it by holding a hacksaw against it while spinning it in the lathe. That worked but was very slow and shook the lathe a lot. By far the best way was to just saw it in a vice with the hacksaw.

I drilled the hole down the middle on the lathe. I had trouble centering the pilot drill. You are supposed to use a special center drill as described here, but I don't have one of those so I used the surprising technique called "catching the centre". Here are a couple of excellent videos I found that describe this technique: -





Once I had got the drill started I put the chuck back in the tailstock and drilled the full length with 1mm, 2mm and 3mm drills.

Here are the finished bearings :-



The RepRap instructions suggest that the bearings should be made after the spindle but I think it is better the do it the other way round. That way you can try the bearings against the spindle while it is still in the lathe and turn the spindle down to the right fit.